brass that is too long could prevent the slide from going all the way forward = out of battery. tiny differences as you've noted won't make a significant difference in the type of accuracy that is required for that type of shooting.īrass that is too short, and i mean waaay too short, will slip a little farther into the chamber to the point where the extractor grabs it and prevents it from slipping any farther. the typical IPSC shooter, which probably describes a majority of the folks on this forum, is less concerned about getting the utmost accuracy from their ammo since their targets are large, close and they're shooting fast. the most import is whether it functions in your gun. For example, if you have a case trimmer and prep tool, you can get the most out of each case and exponentially increase your savings.Part of the answer comes down to practical issues. With any of the companies that I listed, I can normally get 5-20 reloads for each case, but it also depends on the tools you use. Above all, I prefer to load Lapua brass over any other brass case because of the quality. The reason is quality of the brass is normally better with the major brands. You’ll see these in military-issued ammo and some pistol cases to help keep the primer locked into the case during transport and firing.Ībove, I stated that I prefer to load brass from the major companies that I trust to carry in my CCW.
0 Comments
Leave a Reply. |